If you just dig slowly, you can't walk slowly.
By excavating the movement of each cylinder, it is determined that the cylinder in the excavation part is slow, and then it is determined whether the cylinder is damaged or the multi-valve valve of the multi-valve is matched with the cylinder, and whether the cylinder or the valve is determined by the exchange valve block. The problem with the block is determined and then repaired or replaced accordingly.
If you just walk slowly, the excavation is not slow.
1. The transfer case is not in place.
2. see if the transfer case and the front and rear axle drive shafts are broken or the drive shaft bolts are loose.
3. If the mini mucking loader is hung in a low gear, pull the travel lever to see that the front and rear axle drive shafts do not rotate. If it rotates, but the mini mucking loader still cannot walk, there may be problems with the front and rear axle pockets or the axle.
4. If the travel lever is pulled, the drive shaft does not rotate, disassemble the motor base and see if the motor spline sleeve is damaged.
5. Pull the walking lever. If the motor spline teeth do not rotate, use the elimination method to see if there is a problem with the single multi-way valve or the hydraulic motor.
6. look at the transfer box for damage.
The slag machine changed the semi-mechanized and intermittent slag shipment of the original construction and required a large amount of manual coordination of low-speed high-risk and high-cost state. Use the mini mucking loader to find out the faults in use and fix them in time. In order to better improve the work rate.
