The mucking loader manufacturers share the conveyor belt as a spare part (consumable) for the coal mine mucking loader. The service life of this conveyor belt is about half a year. If maintenance is performed immediately, it is not possible to apply it for seven to five months. . You can also remove the old conveyor belt of the mucking loader first, and then replace all the buffer rollers inside (or replace without rotation). The specific practices are as follows:
1. Raise the elevator hydraulic cylinder of the coal mine mucking loader a little.
2. Put the new conveyor belt from the back to the bottom and gradually wear it forward. Pay attention to the front scraper. The transmission belt is on the buffer roller and directly under the front scraper.
3. Then pull 4 ~ 5 meters from directly below the shovel of the mucking loader for mining, and then pour back home. In the past, go through the driven barrel and do not pass through the rectangular square tube.
4. Pull the conveyor belt to the back, use a large tractor or person to put a thin wire on the belt buckle and pull it back until it is dragged to the back of the drum.
5. Remove the thin iron wire, fasten the belt buttons, adjust the anchor bolts, and adjust the mining loading loader for mining. The tension is moderate, and the tight transmission belt breaks quickly. It's like people are dressed up.
