The mucking machine conveyor belt is used properly. If used improperly, one may be used for one month or even one to twenty days. And the price of a conveyor belt is about 2,000 yuan, which is not cheap, so maintaining the belt is very important for the mine. The following editors from the manufacturers of mucking machine, wheeled mucking machine, and coal mine mucking machine share seven ways to properly maintain the mine's mucking machine conveyor.
First, depending on what mine we are, such as acid mines, such as sulfur-containing mines, alkaline mines, such as limestone mines, phosphate mines, and cement mines, these ores may cause the conveyor belt to shrink, just like we wear cotton shirts , The more you cross the smaller. We must pay attention to mines like this. We must always check the tension of the conveyor belt to see if the conveyor belt is too tight. If it is tight, we must loosen the screw of the adjusting belt a few times. Changes in any of the details of the mucking machine. Look at the mucking machine in use with a changing perspective. It's like we have to loosen the belt when the waist becomes thick, otherwise the waist belt is uncomfortable, and the belt is pulled too tightly or the belt is damaged quickly, or the driven roller is pulled and so on. So check the tension of the belt every day when you turn on the machine.
Especially when the mine is shut down, the conveyor belt should be dismantled for storage. Be sure to keep away from these acids, alkalis, sulfur and other items that will cause the conveyor belt to shrink.
Second, mines such as bauxite, phosphate, turquoise, etc., particularly like sticking rollers and rollers, the thicker they get, the conveyor belt is very tight, and it is easy to pull apart from the edge of the belt. So often use a shovel to get rid of all the mud on the drum.
Third, operator reasons. When pushing the slag, the pile is very high, and many people will bury the shovel mouth into the stone pile. At this time, there are large stones under the shovel mouth to just against the rotating conveyor. Over time, the life of the belt will decrease.
4. Some operators, when the mucking machine is walking, the belt continues to rotate continuously. Large underground stones or large stones near the wall sometimes accidentally hit the conveyor belt, causing injuries and damage to the conveyor belt.
Fifth, some operators operate improperly, and the digging teeth are directly pressed to the rotating conveyor belt, causing damage.
6. If the metal ore is too hard and very large, we must pay attention to it. We cannot forcely push the large stone out of the gantry, as this may wear or hang the conveyor belt. Some mine brethren, the stone cannot pass through the gantry, and it needs to be pushed over with digging teeth. The stone finally passed, and the belt was broken. The belt was obviously caused by the operator, but the owner said that the quality of the belt was not good.
7. The idler is accidentally dropped in the conveying rack, obliquely supporting the rotating conveyor belt in the conveying rack, and it is easy to hang the conveyor belt.
