ban
Position:Home  /  Product Wiki  /  How To Maintain The Bucket Teeth Of The Tunnel Mucking Loader?

How To Maintain The Bucket Teeth Of The Tunnel Mucking Loader?

Date:2022-06-20     Label:

mucking loader

tunnel mucking loader

mucking machine

The bucket tooth of the tunnel mucking loader is an important consumable part on the mucking machine. It is a combined bucket tooth composed of a tooth base and a tooth tip, and the two are connected by a pin shaft. Since the worn out part of the bucket teeth of the small slag scraper is the tooth tip, as long as the display tip is replaced, the material is mostly alloy structural steel or high manganese steel.

The working load of the small tunnel mucking loader during the break-in period usually cannot exceed 60% of the additional working load, and an appropriate workload should be arranged to avoid the occurrence of overheating on the site caused by the long-term continuous operation of the tunnel mucking loader.It is best to pay attention to and check the various surface indicators regularly. If the bucket teeth of the slag scraper appear abnormally, stop the car in time to clean it up. If the cause is not found, the operation should be stopped before the fault is removed.

Pay attention to lubricating oil, hydraulic oil, coolant. Brake fluid and fuel oil level and quality, and pay attention to check the sealing of the whole machine. During the inspection, it is found that there is too little oil and water, and the reason should be analyzed. At the same time, it is suggested that during the running-in period, every shift should add lubricating grease to the smooth points, of course, if there are special requirements, it can be excluded.

Regularly clean the tunnel mucking loader, and adjust and fasten loose parts in time to prevent the loose parts from aggravating the wear of parts or causing the parts to be lost. After the running-in period is completed, the small slag scraper should be forcedly protected, and the inspection and adjustment operations should be done well. At the same time, pay attention to the replacement of oil.

If the damaged bucket teeth are not replaced in time, the operating efficiency of the tunnel mucking machine will decrease, and the fuel consumption will also increase, and the efficiency of mucking machine will also be affected.

+

+

Please leave a message
skype
message