1. Make sure to butter the nozzles of each active part twice a day until the butter overflows from the gap of the active part; it should be ensured that the lubricating parts or calcium bases of the shaft, shaft and bearing are connected to the joints in all directions once every three days. Grease to ensure its lubricity and prevent oxidation.
2. Before using the crawler mucking loader, the hydraulic oil must be added to the fuel tank by more than 5%. The hydraulic oil should be replaced after the slag slag machine works for 100 hours for the first time. The second replacement can not exceed 450 hours, and at least every year. Replace the hydraulic fluid once. The hydraulic oil filter should be replaced at the same time to ensure the cleanliness of the fuel tank.
3. Regularly check whether the oil pipes are bent, twisted or even damaged. If they are found, they should be replaced immediately to prevent the pipeline from flowing smoothly and the machine can not work normally. Check whether the seals of each hydraulic component are damaged or not, which affects the sealing effect. If found, it should be replaced in time.
4. When the crawler mucking loader is working, it is not allowed to force the block that exceeds the conveying capacity of the machine to the conveyor belt to avoid mechanical overload failure; prohibit the electrical equipment from hitting the water during operation to prevent leakage; The hard objects in the section should be removed in time to prevent damage to the track.
5. After the machine is used for half a year, check the roller, guide wheel, sprocket, chain rail and track plate. If the wear is serious, the impact should be replaced in time; the slag machine tooth can not be used again after wear. Replace to avoid damage to the tooth holder.
6. After the slag slag machine is finished, the machine should be cleaned, waste oil should be injected into the track and scraper chain to prevent oxidation, and the service life of the track and scraper chain can be extended.
