In mining machinery, there are many ways to use the machine, and you should pay attention to it during use.
1, normal use of oil temperature
Although impurities enter the hydraulic system, it is inevitable, but if there are too many impurities, it will easily cause the oil temperature of the whole machine to be too high. If the machine is running at high temperature for a long time, not only the operation of the whole machine will be weak, but also the premature aging of the machine will be reduced. The life of the machine, so we should always check the temperature of each component during the use process, find the problem immediately stop the inspection, and find the fault in time to eliminate.
2, exclude the crawler mucking loader hydraulic oil impurities
In the environment working in the mine roadway, dust is inevitable. When working, hydraulic oil, oil pipe, operating valve, oil cylinder and other joints should be sealed as much as possible to block impurities from entering the source of the oil circuit; The protection work ensures that the machine can work normally. When cleaning the oil circuit, take protective measures as much as possible to prevent impurities from entering the hydraulic system when replacing the hydraulic components.
3, crawler mucking loader maintenance, repair
The slag slag machine will inevitably have various failures during use. Among these faults, some of the faults may have a very small impact on the equipment, some of which are relatively serious, and even cause serious accidents. Therefore, for mechanical failures, regardless of size, it should be eliminated in time to maintain the normal performance of the machine and reduce the possibility of causing more failures.
4. Reasonable management system
In order to ensure the correct and reasonable use of the machine, it is necessary to formulate a corresponding management system to clarify the main body of responsibility, prevention and future. : It is necessary to strictly maintain the daily maintenance work of the machine, so that the machine is in a good working condition. The second is to educate the miners to correctly use and operate the equipment to reduce and prevent mechanical failure caused by human error.
