Most of the muck loader will work in the mine, so the foundation of the muck loader must be disassembled before going down the shaft. Because of the size of the cave, sometimes the mine slag loader will be disassembled and assembled very loosely. At this time, when the slag loader is sent to the mine for installation, you must pay attention to some detailed matters. . The following editor will share with you how to disassemble the coal mine muck loader.
The disassembly of the coal mine muck loader before going down the shaft should comply with the "large" standard, that is to say, try to avoid disassembling the equipment too loosely. It is not easy to install (or the installation is very easy to make mistakes, and it is very easy to make. Lost components) should be maintained and not disassembled as much as possible. If you have to disassemble and assemble, you must store each component and make a good mark. The standards to be followed are as follows:
1. When assembling the slag loader for mining, be sure to tighten the anchor bolts of each part, and check whether the tightness of the sealing ring is suitable and whether it meets the actual requirements of today.
2. When installing hydraulic components, pay attention to cleaning the hydraulic transmission system to ensure its cleanliness and integrity. In addition, check the seal ring to ensure its consistency to prevent dust and debris from entering and harming the equipment life. .
3. After the mining slag loader is installed, an inspection of the entire equipment should be carried out to avoid redundant common faults due to carelessness.
4. When installing the power circuit machinery and equipment of the muck loader, you must find a professional to carry out the installation. (The power circuit is the key driving force of most muck loaders, so its safety factor is very important)
The disassembly of the muck loader is related to whether the muck loader can be used normally, so before the installation work, it must be tested before starting the work.
