The motor of the crawler mucking loader needs to be maintained frequently, otherwise it will inevitably fail after use. If the tunnel crawler mucking loader wants to maintain the motor, the parts of the slag scraper can replace the carbon brush or other parts. So how to operate it specifically, the slag scraper manufacturer will tell you.
The motor of the mini mucking loader should always be used in a dry environment, because it is easy to cause rust in some parts under humid conditions, and the surface of the motor product should be kept clean for a long time, and should not be polluted and hindered by fiber dust. When the thermal protection of the motor has continuous protection action, it should be determined whether the fault is caused by the overload of the motor itself or the protection device. The set value is too low, and it can continue to operate only after the fault is cleared. Motor products can maintain good lubrication during operation. Generally speaking, the motor products of small slag scrapers should be supplemented or replaced with new lubricating oil after 5000 hours of operation. If the bearing overheats or the lubricating oil deteriorates during operation, the lubricating oil should be replaced in time. After replacing the grease, the original lubricating oil should be cleaned up, and the oil factory of the bearing and bearing cap should be cleaned with gasoline, and then the new grease should be filled in the cavity between the inner and outer rings of the bearing. When the life of the bearing reaches a certain level, the obstacles and noise of the electric custom motion will become significantly larger. It is necessary to check whether the bearing clearance reaches the set value, and then replace the new bearing.
Due to the mini mucking loader, the mining mucking rock loader is limited by its own structure, and it is difficult to achieve breakthrough improvements in feed speed, acceleration, rapid positioning accuracy, etc., and can no longer meet the needs of high-speed cutting and precision machining. Higher requirements for performance. The linear motor directly converts electrical energy into linear motion mechanical energy, without the need for any intermediate conversion mechanism. It has the advantages of large starting thrust, high transmission rigidity, fast dynamic response, high positioning accuracy, and unlimited stroke length.
